Floor Care Guide
How often should commercial floors be stripped and waxed?
A practical schedule by traffic level, and how to go longer between the most disruptive job in floor care.
The short answer: a typical commercial vinyl tile (VCT) floor is stripped and refinished anywhere from once a year to once every few years, depending on traffic and on how well it is maintained in between. Many floors are stripped more often than they need to be, because the cheaper maintenance steps were skipped.
Strip and wax is not the only option
Floor finish wears from the top down. If you catch it early, you only have to replace the top layers. That gives you a ladder of options, each more invasive and costly than the last:
- Daily care. Dust mopping and damp mopping with a neutral cleaner. Removing grit does most of the work of protecting the finish.
- Burnishing. High-speed buffing that restores gloss on a finish in good condition.
- Scrub and recoat. Removes the worn top coats and scuffs, then adds fresh finish without going down to bare tile.
- Strip and refinish. Chemically removes all the finish, then rebuilds with sealer and multiple coats. Needed when the finish is discolored, built up or damaged through to the tile.
A starting schedule by traffic level
These are general starting points for VCT, not fixed rules. Your floor's condition should decide the schedule, so inspect it rather than simply following the calendar.
| Traffic | Examples | Burnish | Scrub and recoat | Strip and refinish |
|---|---|---|---|---|
| Heavy | Retail entrances, school corridors, cafeterias | Weekly to monthly | Every 3 to 6 months | About once a year |
| Moderate | Office corridors, clinics, break rooms | Monthly | Every 6 to 12 months | Every 1 to 2 years |
| Light | Private offices, storage areas | As needed | About once a year | Every 2 to 3 years or more |
Signs that your floor needs attention
- Dull traffic lanes while the edges still shine. Usually a job for burnishing or a scrub and recoat.
- Black marks and scuffs that do not come up with mopping. Often solved with a scrub and recoat.
- Yellowing or dark edges. Built-up finish holding dirt, which usually means that it is time for a full strip.
- Exposed tile. The finish has worn through, and tile is taking damage. Do not wait.
How to go longer between strips
- Stop grit at the door. Walk-off matting captures soil before it reaches the floor. Long enough mats make a surprising difference.
- Use the right cleaner. Harsh or incorrectly diluted chemicals dull finish quickly. Most floors want a neutral cleaner.
- Dust mop often. Grit acts like sandpaper underfoot.
- Plan for New York winters. De-icing salt leaves a film that eats away at finish. Add mopping at entrances from November onward and schedule a recovery scrub in spring.
- Protect from furniture. Floor protectors on chair legs prevent gouges that no amount of finish can hide.
A word on stone, terrazzo and other floors
This schedule applies to VCT. Do not apply it to marble, terrazzo or natural stone, which call for pH-neutral products and a different maintenance approach, because acids can etch them permanently. Luxury vinyl tile, rubber and polished concrete also have their own requirements, and many are damaged by traditional wax. Check the manufacturer's care guidance, or ask us to take a look.
Planning the job
Stripping and refinishing means closing the floor while the finish dries between coats. Schedule it for evenings, weekends or a holiday period. For schools, summer break is the natural time. Book early if you want a specific date.
Not sure which level your floor needs? See our floor care services or book a free walkthrough, and we will tell you honestly whether you need the big job at all.
See what your building's plan would look like.
We walk the space with you, learn how it runs, and put a customized scope and proposal in writing. The walkthrough is free and there is no obligation.