Worker in a high-visibility vest pressure washing a city sidewalk with a surface cleaner

Pressure Washing

Commercial pressure washing in New York City

Sidewalks, storefronts, entries, loading docks, dumpster areas and parking decks, washed with a plan for water, surfaces and foot traffic.

Why New York is different

The sidewalk in front of your building is your responsibility

Under New York City rules, property owners must keep the sidewalk and the gutter clean, out to 18 inches from the curb, along the building's perimeter.

The Department of Sanitation inspects during set enforcement windows and can issue fines. Daily sweeping handles the litter. It does nothing for the gum, grease and staining that build up on concrete and make a good building look neglected. That is what pressure washing is for.

Read our guide to NYC sidewalk cleaning rules, or check the current rules on the DSNY website.

Scope

What we wash

  1. Sidewalks and curb lines

    Gum, grime and staining along your frontage, with extra attention at doorways, tree pits and bus stops.

  2. Storefronts and entries

    Entry pads, thresholds and lower facade areas, usually paired with window cleaning so the whole front is finished at once.

  3. Dumpster and trash areas

    Grease, spills and odors around enclosures and trash rooms. Especially useful for restaurants and multifamily buildings.

  4. Loading docks

    Oil, tire marks and debris on dock aprons and ramps, scheduled between deliveries.

  5. Parking lots and garage decks

    Surface cleaning of lots, entrances and decks, sectioned so parking can stay open wherever possible.

  6. Plazas, courtyards and walkways

    Pavers and concrete in shared outdoor areas, cleaned before they become a slip hazard or an eyesore.

  7. Building exteriors

    Lower-level masonry and exterior surfaces using a lower-pressure approach where the material calls for it.

Worker in high-visibility clothing using a pressure washer on a city street

Method

More pressure is not always better

Pressure washing done carelessly etches concrete, blows out mortar joints and strips the face off soft brick and stone. It can leave permanent "wand marks" that look worse than the stains did.

We match pressure, nozzle, water temperature and detergent to the surface. Newer concrete can take more than old brick, and many older New York facades need a gentle, low-pressure wash rather than a blast. If a surface looks fragile, we test a small area first.

  • Surface assessed before any water goes on it
  • Test areas on older or unfamiliar materials
  • Rotary surface cleaners for even results on flatwork
  • Detergents only where the soil calls for them

The plan

What we sort out before the machine starts

Water

Where the water comes from, where it goes, and how drains are protected. Runoff is planned for based on the site, the soil and what the rules require.

Timing

Early mornings, nights or weekends, chosen around your tenants, your neighbors and foot traffic on the block.

Pedestrians

Sections are coned off so people can still get past safely and without getting sprayed, including at your own front door.

Questions

Pressure washing FAQ

How often should a commercial sidewalk be pressure washed?
Busy retail and restaurant frontages often benefit from monthly or quarterly washing. Quieter buildings may only need it a couple of times a year. Spring is a good time for everyone, once the winter salt is gone.
Can you remove gum from the sidewalk?
Yes. Heated water removes most gum effectively. Very old or heavily embedded gum may need extra passes, and we will set expectations when we see it.
Will pressure washing damage brick?
It can if done poorly, which is why we assess the surface first and use lower pressure on brick and older masonry. We would recommend against any treatment we think could damage the material.
What happens to the runoff?
We plan for it before work starts. That can include protecting nearby drains, limiting detergents and collecting wastewater where the site or the soil calls for it. Oil and grease areas need particular care.
Do you need access to water on site?
We will confirm this during the walkthrough. Tell us if you have an accessible spigot and where it is, along with any restrictions from your building or neighbors.
What time of day do you work?
Usually early morning, overnight or on weekends, depending on the block. We will agree on a time that works for your property and is considerate of those around it.

Your sidewalk is part of your building.

Tell us what needs washing and when your property is quietest. We will look at the surfaces, the drainage and the access, then send you a clear proposal.