Patterned stone floor outside a row of elevators in a commercial building

Floor Care

Commercial floor care in New York City

Stripping and waxing, scrubbing, burnishing and ongoing maintenance for VCT, tile, stone, terrazzo and concrete, planned around your traffic rather than a guess on a calendar.

The principle

Good floor care is mostly about what you do between the big jobs

A strip and wax is expensive, disruptive and, more often than people realize, avoidable.

Floors usually end up there because the small maintenance steps got skipped: the dust that grinds down the finish, the wrong chemical that dulls it, the salt that sits on it all winter. Plan the routine properly and the big restoration moves further and further out.

We start every floor care engagement by identifying what you have and what state it is in, because the right method for vinyl tile can permanently damage marble.

By floor type

The right method for each surface

FloorWhere you see itHow we care for it
VCT (vinyl composition tile)Offices, schools, retail, corridorsStrip, seal and finish; scrub and recoat between full strips; burnish where traffic allows.
Marble, terrazzo and natural stoneLobbies, elevator banks, older buildingspH-neutral cleaning only, since acids etch stone. Restoration work such as honing is scoped after inspection.
Ceramic and porcelain tileRestrooms, kitchens, entriesMachine scrubbing and grout detailing, which brings back more than most people expect.
Sealed and polished concreteWarehouses, lofts, showroomsAuto-scrubbing and dust control, with attention to the condition of the seal or polish.
LVT and sheet vinylMedical offices, newer fit-outsLow-speed scrubbing with compatible cleaners, following the manufacturer's care guidance.
Rubber flooringGyms, fitness studiosNeutral cleaners and controlled moisture to protect the surface and seams.
Glossy polished concrete floor reflecting overhead lights in an empty commercial space

Maintenance ladder

Four levels of floor work, from least to most invasive

  1. Daily care

    Dust mopping and damp mopping with the right chemical. This does most of the work of protecting the finish.

  2. Burnishing

    High-speed buffing that brings back shine on a healthy finish in high-traffic areas.

  3. Scrub and recoat

    Removes the worn top layers and adds fresh finish, without a full strip.

  4. Strip and refinish

    Takes the floor back to bare tile and rebuilds it. Needed less often when the steps above are on schedule.

Read: how often to strip and wax

The New York factor

Winter salt is the enemy of a good lobby floor

Every November, the sidewalks of New York start tracking de-icing salt straight onto your floors. It dulls finish, leaves white residue, and grinds into stone and carpet alike.

A sensible winter plan includes more walk-off matting at the door, more frequent neutral-pH mopping in the first twenty feet of the building, and a scheduled recoat or deep scrub in spring to deal with what the season left behind. It is far cheaper than restoring a floor that spent four months under salt.

How we work

Floor work that does not stop your building

Phased by zone

We split corridors, lobbies and suites into sections so there is always a safe path through the building.

After-hours timing

Work is scheduled for evenings, overnight or weekends, with enough drying time before anyone walks on it.

Clear signage

Wet floor signs and barriers go up before the first drop of water, and come down only when the floor is ready.

Questions

Floor care FAQ

How often should commercial floors be stripped and waxed?
It depends on traffic and how well the floor is maintained between jobs. A busy corridor might need it every year or so, while a lightly used floor on a good scrub and recoat routine can go much longer. We recommend a schedule after seeing the wear.
How soon can people walk on the floor?
Finish needs to dry fully between coats, so we plan the job around a window when the area can stay closed. We will tell you exactly when the floor can reopen before work starts.
Do you work on marble and terrazzo?
Yes, routine care of stone and terrazzo is part of the service, using pH-neutral products. Restoration work such as honing or polishing is assessed in person, since it depends on the stone and its condition.
Do you move furniture?
Yes, we can move standard furniture as part of the job when agreed in the scope. Tell us about anything heavy, fixed or sensitive during the walkthrough, so we plan for it.
Can floor care be part of our regular cleaning program?
Yes. Daily care can be written into your commercial cleaning plan, with burnishing, recoats and strips on a set rotation.

Find out what your floors actually need.

We will look at the floor type, the wear pattern and the traffic, then tell you whether you need a full restoration or just a better maintenance routine.